Dremalink T6 Clone - E 08 Error

[danny]

My friend has a a clone T6. It used to boot ok before. All of a sudden it does not boot (blank screen) and the receiver displays E 08.

When you first boot the box, the receiver displays "H1", then a screen pops up on the tv showing picture of couple of T6 boxes, then after that the screen goes blank and nothing happens even when you push different buttons on the remote, and the receiver displays the E 08 error.


Anyway to reinstall a software on this clone to getting this box going again?

[KIDWCKED]

try this you got get into the internal recovery by powering off in the back button then press the front channel down key and when you see about 4 to 5 under scores in the display like this------ press the channel up key,wait a few seconds and recovey will come up then you just proceed to wipe data factory reset and wipe cache partion.

[danny]

try this you got get into the internal recovery by powering off in the back button then press the front channel down key and when you see about 4 to 5 under scores in the display like this------ press the channel up key,wait a few seconds and recovey will come up then you just proceed to wipe data factory reset and wipe cache partion.

Thx Kid. Is it safe to perform this procedure on a clone?

[KIDWCKED]

Thx Kid. Is it safe to perform this procedure on a clone?

cant see why not..basically its a factory reset..then load ur clone files..

[danny]

cant see why not..basically its a factory reset..then load ur clone files..

Ok thanks. Will give that a try.

[danny]

So, I tried the above procedures, but nothing happens. I turned off the receiver with the back switch, and pressed the down key (on my receiver there is only volume keys for up and down. no channel keys, so pressed the volume keys) no underscore line comes up. Nothing happens. The display is blank.

[KIDWCKED]

here is the volume key procedure..

1) turn-off the box at the back.
2) While holding the down volume button in the front, I turned the back switch on and the ---- appeared in the front panel.
3) Then I pushed the up (volume) button and waited for about 5-10 seconds.
4) The command console button appeared in the TV screen with 5 options selection.
5) I Chose the factory reset menu
6) Then it asked me to reboot?
7) When I rebooted, the Kodi screen now appeared.
8) I followed the initial screen dialogue (Next-->) (the usual after you factory reset)

not sure if this workx with clones...

[danny]

here is the volume key procedure..

1) turn-off the box at the back.
2) While holding the down volume button in the front, I turned the back switch on and the ---- appeared in the front panel.
3) Then I pushed the up (volume) button and waited for about 5-10 seconds.
4) The command console button appeared in the TV screen with 5 options selection.
5) I Chose the factory reset menu
6) Then it asked me to reboot?
7) When I rebooted, the Kodi screen now appeared.
8) I followed the initial screen dialogue (Next-->) (the usual after you factory reset)

not sure if this workx with clones...

Thanks Kid. That worked perfectly.