Jynxbox V30 missing some channels (maybe someone has channel file?)

[xzotick]

I have a DPP44 with power inserter (on port 1).
119 port 1, 110 port 2, 129 port 3.
I have a dreamlink T4 with HD bin loaded on port 2 with separate cable.
I just got a Jynx v30 and connected to port 3.

The T4 I believe has all the channels.
The Jynx however is missing quite a few.
Some on 110, 119, and 129.
I have noticed it a little flaky. Sometime the wifi dropped for no reason.
The ethernet was a little tough to get an IP.
I was hoping someone might have a jynx complete channel file I could try...
I think the firmware on the box is a little old. It reads AHC as military channel.
241 says it ABC or something like that.
I did try the jynx on the t4's cable to rule out bad cable...
But I dont think that is what it is because quite a few of the channels work fine...

thanks for any help

[st2014]

not sure if this will help make sure your settings are correct for all sats make sure all lnb are set correctly

[jvvh5897]

Well, there is a ch list from a year ago in the files section. I think the jynx does not rename what the stream carries for the channel name (at least there was a post I read a while back about not having long channel names and that is a re-mapping along the same lines). There are lots of posts around that tell you the jynx box does not do well with prov switches and LNB, but since you have a power inserter, I would think that is not your issue. The channel list is not that hard to figure out, so you should be able to manually (or by using a program to auto correct) fill in stuff--I'm guessing that if one really wanted to the ALI Editor could be set up to correctly work with jynx box list as well.

[jvvh5897]

Perhaps you should post the channel list of the dreamlink T4 and see if someone is willing to do the work to take that and output a udf file for the Jynx.