i just bought a used jynxbox and am having the same issue as my older one...the picture freezes after about 10-20 minutes (audio still works), then the whole box freezes a minute later, at which point i do a hard reboot (power switch toggle on the back) and its back to normal for another 10-20 minutes and then it freezes again
the one i have now seems like an original..i believe my old one was a close as it said jynxbox v4 as the model name under system information
as for the new one:
1. the box is labeled on the front (by the channel display) as a v3, but once i go into system information it says that it's a v2
2. when i try to change the firmware (tried to go to 2.43, then 2.39), it doesn't show it as changed in system information...still shows 1.2.42
this is what it says under system information for the used one i just bought:
model: jynxbox v2
loader version: 1.2.20
hardware version: 1.0.3
database version: 1.0.1
firmware version: 1.2.42
build date: 2013-7-24
does anyone have an idea if this could be an issue with something other than the box? a switch? lnb? cabling? dish?
i have a dreamlink t5 that almost works fine, but also drops signal when i change channels sometimes, which also requires a power off/on to get the picture back
so, in summary...the jynxboxes freeze (the new one also sometimes drops signal and requires a reboot) and the dreamlink drops signal sometimes when i change channels....both require reboots to get back to normal
kind of at my wit's end here...can anyone help?