Is my setup correct

[T_Tronix]

Here is my switch setup I was wondering if its accurate. I got a Sub B3V and I wanted to add a Limesat with both B3V and D1SH.

14384

Also what should be the settings for the dishes coming out from my 44 switch in Limesat?

[nixon_r]

That isn't going to work. That big switch that the bev satellites are connected to is a DPP44 switch and it uses diseqc commands to operate, presently 91 is on diseqc port 1 and 82 is on diseqc port 2. You will need to connect a line from additional port 1 to port 1 of the little diseqc switch, connect a line from additional port 2 to port 2 of the little diseqc switch, connect the line from the 110 LNB to port 3 of the little diseqc switch, connect the line from the 118/119 LNB to port 4 of the little diseqc switch, from the little diseqc to your limesat.
The dish settings for the limesat would be 91 on diseqc port 1 - LNB type OCS-DP - LNB freq 11250, 82 on port 2 - LNB type OCS-DP - LNB freq 11250, 110 on port 3 - LNB type single or standard - LNB freq 11250, 118/119 on port 4, LNB type single or standard - LNB freq 10750.

[T_Tronix]

Cool thanks I'll try it out.

[T_Tronix]

Another question how will I be able to connect 7 lnbs to one ird? for instance 61.5 72 91 82 110 119 129, was just wondering...don't have these but was curious to know.

[nixon_r]

Again it all depends on what type of LNBs you are using, you are using Dpro so I would use 2 DPP44 switches and then combine the output of the DPP44s with Ecoda 22KHz switches then to the receiver. That would run you lots of money as well, so to be realistic about this and you are using a FTA receiver you could use a decent diseqc switch and 22KHz switches.