JynxBox slow down when EPG fills in

[Rizz]

Hi Guys ,
I want to ask few things about jynxbox HD. channel change is very slow and when you load EPG scrolling through channels is to slow for me . I did factory reset but no help so I am here asking all the testers if they have this issue or I need to do some thing else to fix that . plus I have 125GB usb flash drive which I am unable to record it show its recording but when i try to play I get choppy picture most of the time I don't even get picture just sound.

Any help is greatly appropriated.
Thanks

[Anubis]

Channel change is a server issue and not the box.
Sounds to me like you are not pointing your remote at the box but your tv (which is a common habit).
Are you trying to play your recording while your are recording? If so that would be one reason.

[Rizz]

I have dreamlink HD same server no issue overall I notice that box run slow for some reason.

[Lowteck]

From observations I have noticed there is only one cpu. This by default when trying to decrypt satellite information makes a poor multitasking partner. Most other receivers had more than one processor. One thing you can do that I found was to cut the timeshift off. That is the one where you can pause and back up up to 30 minutes. That being on also slows down the response from the remote if you have a large USB. It is not as bad if you are using 1G or less. To be blunt they have not done their homework on multitasking procedures. You either get a very good like the regular dish receiver or you get a corner cut cheep Jynxbox, or somewhere in between like the nfusion HD. I can live with the Jynxbox for the price.