RQSSSP help

[gwentamalo]

Hi! I have a fortec converted to pansat 2700 running on PUFF, until last week my box was running but started freezing a lot two weeks ago so i decided to reprograme the box but the RQSSSP is connected but can't comunicate with client for the box to change channel. what did i do wrong? TTL are you around? Please anyone help me. Tank You.

[satrax6]

Your box freezing is usually due to changes being made to the server or a problem with your network and sometimes your ISP. You should try doing another factory reset and check all of your settings including your COM Port settings. Good Luck

[jos25]

QUOTE=gwentamalo;868458]Hi! I have a fortec converted to pansat 2700 running on PUFF, until last week my box was running but started freezing a lot two weeks ago so i decided to reprograme the box but the RQSSSP is connected but can't comunicate with client for the box to change channel. what did i do wrong? TTL are you around? Please anyone help me. Tank You.[/QUOTE]

what did you reprogramme with, make sure the bin and boot files are correct. \\then check your rqssp client. \\PUFF or LZMA iks bin will be in files section.[

[gwentamalo]

Thank you! I'm not good with computers and electronics, please direct where to set the COM Port and tell me witch file to download please.

[jos25]

if the box was running 2 weeks ago. it should be properly programmed with necessary files. when you reprogrammed, did you use the same file.
to set the comm port, open the rqsssp client with notepad or word pad. it will show list of items. near top of page will see com port, if it is set to something other than com one change back to comm 1 save file, close. then click on rqssp client to start and if ports are correct it willl connect. good luck.

[gwentamalo]

if the box was running 2 weeks ago. it should be properly programmed with necessary files. when you reprogrammed, did you use the same file.
to set the comm port, open the rqsssp client with notepad or word pad. it will show list of items. near top of page will see com port, if it is set to something other than com one change back to comm 1 save file, close. then click on rqssp client to start and if ports are correct it willl connect. good luck.


Thank you Jos25!I set it to com port1 but it says, i'm connected client ready waiting for request but the channels don't show on my computer. my system info is JVVH-LZMA-V218F_em <Nkk_Mty>:75 07 June 2009

[Imsomebody]

Your first post and only nine years to catch up.

[jets]

It could be the box itself too, the power supply. Just go out and find a Viewsat for $10 or less and replace the Pansat. Then run the GooWare windows client... Fixed for $10.