PDA

View Full Version : Mulitple Donation's


cheezed
10-25-2012, 10:14 PM
First off, glad to be back. Several months ago I picked up 6 codes for family members and 2 of the 6 I am using for myself on a SV8000 and Ilink9000P. All this time I have never used both receivers at the same time until recently and when I do the Ilink freezes like mad and the SV8000 is fine. So there has to be some type of conflict. I was issued 4 codes that are different and 2 that are the same that I am using. Also I was issued the same Port# and Deskey for all 6. If this helps I picked up these codes here but I cant remember who the member was. Any idea's.
smallyjohnson
10-25-2012, 10:28 PM
the 2 that are the same is the likely culprit ....IF....those are the ones your using..... try a different port with it ...example if your port is 10610 use that for one and 11610 on the other ...just use 10 on front of one and 11 on front of other ... and if you got from wufman ..you are SOL ...good luck "lil dik"
Styx_N_Stones
10-25-2012, 10:42 PM
Small Johnson...?
Junior Member...?

Now thats funny... LOL!!!

Sorry, couldnt help it...
cheezed
10-25-2012, 10:47 PM
smallyjohnson, I will try changing ports. I'll report back with the results. Thanks for the suggestion.
Anubis
10-25-2012, 10:59 PM
Make sure both units are not on the same ip on your router as well.
gwrowe
10-25-2012, 11:57 PM
A fix for this is, try grounding your dish if that doesn't work then use this fix, replace your switch's with a 22khz sw, it worked for me!What is happening is the 1 receiver is overpowering the other.
cheezed
10-26-2012, 04:51 AM
Confirmed that my router has assigned two different ip's to each receiver. Also tried 4 different port#'s 10410, 10510, 10910 and 16110 so I reverted back to my original port# and I am back to constant freezing on Ilink9000P. Thanks for the suggestions.
cheezed
10-26-2012, 04:52 AM
No switches in my set-up using dish 1000.
alpacino
10-28-2012, 03:51 AM
I did get mine from him too, time to renew as I find it dead. Any ideas?



the 2 that are the same is the likely culprit ....IF....those are the ones your using..... try a different port with it ...example if your port is 10610 use that for one and 11610 on the other ...just use 10 on front of one and 11 on front of other ... and if you got from wufman ..you are SOL ...good luck "lil dik"