Vs 9000 ver 2 having problems booting up goes on and off

[GeoSat1]

Hi was wondering if anyone has the bootfix ver 2 for vs 9000 . My unit is currently stuck on it and will not work properly.

[bobby]

try loading the "virgin ch file" to get out of boot loop with vs9000HD, in most boot loop cases with the vs9000HD loading a virgin ch file works best, good luck, keep us posted

[GeoSat1]

Hi Do you have a copy of the latest virgin channel list for vs 9000, I did the boot fix ver 2, now it just stays locked on boot mode, I am trying to download the factory on it via loader 2. Still cannot get access to the menu. I tried with the usb doing the VS 9000 HD channel editor and data, but it would only read usb and then go back to boot. I also tried to load via the loader2, but was not successful.

Option C - Fix Clean Install without Menu access:

1. 'Power Off' with the back panel switch
2. disconnect antenna
3. on USB Drive:
* copy current Release bin
* create a directory "USB"
* copy Factory bin to "/USB/PFTAHDSW.pgm"
4. plug USB Drive into front port
5. with only a TV connected, 'Power On' with the back panel switch
6. the display shows: "BOOT", "CHECK USB", "DOWNLOAD"
7. when the display shows: "ERASE" - pull the USB Drive out
8. wait for unit to complete Erase, Program and re-boot (Notes #3, 4)
9. Factory Default
10. plug USB Drive into front port
11. Receiver Upgrade=>USB Release bin
12. wait for reboot
13. Factory Default
14. 'Power Standby' with remote or front panel switch, wait 5 sec.
15. 'Power Off' with the back panel switch
16. reconnect antenna
17. 'Power On'
18. setup Options
19. see Setup Antenna & Scan Satellites below

Do a Serial load of the Factory bin as a last try procedure if the Boot "CHECK USB" load fails.

I am stumped I downloaded factory vo133 and the newest bin Pftahdsw-110802h

[GeoSat1]

Hi Do you have a copy of the latest virgin channel list for vs 9000, I did the boot fix ver 2, now it just stays locked on boot mode, I am trying to download the factory on it via loader 2. Still cannot get access to the menu. I tried with the usb doing the VS 9000 HD channel editor and data, but it would only read usb and then go back to boot. I also tried to load via the loader2, but was not successful.

Option C - Fix Clean Install without Menu access:

1. 'Power Off' with the back panel switch
2. disconnect antenna
3. on USB Drive:
* copy current Release bin
* create a directory "USB"
* copy Factory bin to "/USB/PFTAHDSW.pgm"
4. plug USB Drive into front port
5. with only a TV connected, 'Power On' with the back panel switch
6. the display shows: "BOOT", "CHECK USB", "DOWNLOAD"
7. when the display shows: "ERASE" - pull the USB Drive out
8. wait for unit to complete Erase, Program and re-boot (Notes #3, 4)
9. Factory Default
10. plug USB Drive into front port
11. Receiver Upgrade=>USB Release bin
12. wait for reboot
13. Factory Default
14. 'Power Standby' with remote or front panel switch, wait 5 sec.
15. 'Power Off' with the back panel switch
16. reconnect antenna
17. 'Power On'
18. setup Options
19. see Setup Antenna & Scan Satellites below

Do a Serial load of the Factory bin as a last try procedure if the Boot "CHECK USB" load fails.

I am stumped I downloaded factory vo133 and the newest bin Pftahdsw-110802h

Fixed thanks for the help