jynx new soft ware

[draxhall]

hello good morning i am running the 206 file on my box i download the new file and put in the usb slot when i go to upgrade receiver the receiver is saying no file if i go to start it says no match file found need help please

[Anubis]

Did you unzip the file before putting on to your usb stick?
Is the usb stick formatted to fat32?
Make sure you use the front usb port as the back one does not recognize a usb with file 206.

[iq180]

the rear usb port dont work for upgrades.

[draxhall]

front port would not work when i first upgrade i did it with back usb

[draxhall]

front port would not go to upgrade by usb back port is going to upgrade by usb but saying no match file found i am using the same usb that i put on firsf file

[Anubis]

Try downloading the file again then unzip it then drag and drop instead of cut and paste it to your flash drive then try again.

[iq180]

did you do a factory reset after you loaded the 206 file, if you did not, you need too.

[smallyjohnson]

every time i have loaded a file to mine i must insert a flash drive in BOTH front and rear slots ... due to same message you are getting.... it takes a few tries each time ..hope this file corrects the dbl and triple channel issues