Net Application Settings

[jabroni]

Delete Thread

[hutch]

installations/network/net application/DREAM... when you factory default you automatically default to Nano Stream in which your settings can't be changed so you must change this to DREAM

[torpainter]

Back when NFPS changed to their new IP, I made some changes to my net settings. I experience some severe freezing sometimes which I do not think is related to NFPS.

I tried to look at my NET settings and noticed that it now just shows "default" for several of the settings. I cannot changed any of them either. When I hit left or right, it just stays on DEFAULT. I cannot even see what my port number is anymore when I am quoting in the up/down thread?

Any suggestions? I tried a software factory default, no luck. I do not have a computer with a serial port anymore either. Not sure if that may work. ie connecting it to the computer and putting on the base files and than updating?
Actually there is major freezing being reported

[gwrowe]

What you will likely have to do is reload your fact file through the 232 port, but like you said you no longer have one in your computer, but you could go to the computer store and get 1 on a separate card or get a usb to 232 serial port converter.