Connected but no picture

[bad1]

What is the correct ip/domain for 16110 and 10510. It was working with the ip I had in it till it said wait 3 sec and it did a complete reboot and changed ip/domaim from the info posted and now it is connected but I have very limited channels that work.Did I do something wrong or are we still recovering from last weeks ecm.Any help would be appreciated. Thanks for hearing me out

[ticktack]

if it worked with other ip,then reload all previous donation numbers and hard reboot. recovered , no problem.

[bad1]

Problem is I don't remember what it was

[bad1]

Crazy thing is I zerod out port one and it still says connected

[pogoss]

Do some reading here:
http://phoenix.satfix.net/showthread.php?120571-NFPS-Announcements-Thread-Only!!!!!
After entering network information, reboot your receiver

[bad1]

Okay so I went through my whole setup again and discovered that I didn't turn my 22KHz Tone to the on. Now it works. Thanks all for your help

[bad1]

Stangely enough if I leave 22KHz off the limited channel that work run freeze free without disconnecting. Just an observation. I'm running a nano prem

[Anubis]

Strangely enough I found this that may shed some light...http://phoenix.satfix.net/showthread.php?121004-22kHz-On-or-Off&highlight=anubis+switch

Pay attention to post #7 from pugs...