file f27 back to f24

[tbird686]

i don't have the serial cable to load the files can i use usb to load the files? i want to step it back to f24 so i can try bev.

i have the hd nfusion running dish thats all good. and well can you can you set noi to have 2 different p$ off it. like to be able to switch between them?

[bobby]

yes, use the usb, you will need to add the ip's for bev and dn that the r24 file uses and if r24 does not work for you than use r25 which uses the same ip's as r24,

you can enter upto 4 servers in noi but if memory serves me I think it will only switch between the first 2 if using the same provider and will switch between north and south without issue

[tbird686]

Will the wizard program fill in the proper ip needed for bev...

[Glatt]

Why not use the webloader for easy access! Put your box's IP into internet User name is admin and password is 0000

[riverman]

add these external IP addresses to your computer
IP/subnet mask: 123.108.108.138 / 255.0.0.0
IP/subnet mask: 123.108.109.022 / 255.0.0.0

[tbird686]

okay i loaded r25 and the newest transponders i could find.....i found 110, and 129 and scanned them with the motor......but i'm not seeing 119 at the moment. i had it before the bin change.....is there any reported problems with this? i used nf_hd_v1.3sR_25.....then followed with nf-hd-transponders-062612-r25f-fixed. oh and some how 91 and 82 were automatically loaded too......i thought i was going to have to do that manually as well

[tbird686]

well i tried the nf-hd-transponders-031512-r27f file and ya i see 119 again with no problem......so i see my factory file is still the 25.....so i'm wondering can i get beaver now if i join there club?

[tbird686]

all went well ..........beaver is up and all signals are strong.....so when using r25 us the r27 latest transponders...

[Koko868]

Hello

I am running NOI on Nfusion HD. I am using the r27file and south is running fine but can't connect to the north. Am I using the right file for bev 91?

[ssr316]

Hello

I am running NOI on Nfusion HD. I am using the r27file and south is running fine but can't connect to the north. Am I using the right file for bev 91?

I believe the 27f file is only compatible with south. You have to use 24f or 25f if you'd like to access both north and south.

[Glatt]

25f is good for bev! The first few transponders on 119 are spot beams and will not show a signal, just scan 119 it should be OK!