switching from serv pro to extreme file?

[drparty333]

what would be the procedure for switching from server pro to extreme...
where would i start.... i just don't want to mess up buddy's box..thanks


Xtreme Instruction for Nfusion SD Only
- If you are already using Boris T4 / T54 bin, start on step 1
- If you are already using NOI bin, start with step 5
- If you are already using Nfusion 58W bin, start with step 7
- If you are already running on an older Xtreme bin, just load the latest Xtreme bin in the
“Main” using the Nfusion loader.
1. Load the boot_g3x_to r3x_v1.23.bin file in BOOT mode.
2. Load this file u48 factory file from July 2009 also in BOOT mode.
3. Load this file next... boot file v.130 also in BOOT mode.
4. Load this file 090928 sol phoenix sd v153 1 (Maintenance release) in MAIN mode.
5. Load the file named boot_126.bin.in BOOT mode.
6. Load the file named nfusion_factory_U17.bin in BOOT mode.
7. Load the latest XTREME file (XSTV*.bin) MAIN mode.
8. Do a factory default <- very important! Menu > Newcamd Setting > Factory Default
9. Now Menu TO Newcamd Setting > Server Info>OK> 5585
Enter your info
“C” button – clear
“i” button – cap / small letters / number
Menu button - previous menu
When doing url leave second one blank
Same as password and username and port to leave second one blank.
When doing DES make sure you do 2 number then a space and so on
Like this...

[gwrowe]

What S/W is already on the box? Was it setup to run with noi? If so start with step 5. Check S/W version in menu before proceeding with the conversion.

[drparty333]

the sw on the receiver is:

boot: r3x 1.26
sw: nfps 12010

i am not sure but i think i would start at step 3....
i want to install Bin 4.09v2..thanks for any help..

[gwrowe]

You are right start at step 3!!

[drparty333]

thanks gwrowe...ill try that..