Can not get connected

[satjunky]

I have been down for awhile, I cannot get a connection.

I entered NPP 9.15 and it changed all my channels, I did a factory reset and then just entered SKY 1.12 and then entered my info and still the channels are numbered different.

What am I doing wrong?? Can someone help me.

Thanks,

[polar bear1973]

try, press fn1 on your remote then reboot

[satjunky]

thanks, I tried this and still no connection...

[ICEMAN]

could you provide more info please like your settings.thank you

[djrm54]

do you have a internet connection?

[satjunky]

yes, I just updated the EPG...

[satjunky]

sorry, but what settings...

[ICEMAN]

your antenna settings and what p/s are you using,have you updated your ip adress lately,,

[gwrowe]

Did you setup all the other menu areas in your receiver, like user settings etc.?

[Ricktoo]

I think your supposed to insstall sky 1.12 THEN do your Factory reset, your first post says you did the reset then installed 1.12, also I had a connection problem when they switched servers and later found out the new domain nfps is 1.nfsps.bz not .ws like before

Hope that helps

[mrnov4]

Hi i need some help i dont have service and need to know what to do. I have under Net application the following:

server no: 1

softcam: newcamd

input type: domain

server: 1.nfps.ws

port: 10510

Au: off

PLEASE HELP AS I LIKE TO KNOW WHAT TO DO TO GET MY CHANNELS BACK. i HAVE SPENT WAY TO MUCH ON THIS STUFF. THANK YOU IN ADVANCE.

[mrnov4]

i forgot to mention that i also did. 1.nfsps.bz

server no: 1

softcam: newcamd

input type: domain

server: 1.nfsps.bz

port: 10510

Au: off

[gwrowe]

Change to Caps, should look like this, 1.NFPS.BZ or you can use the IP, which is 37.46.112.201, just change domain to IP.

[samdrucker1909]

your antenna settings and what p/s are you using,have you updated your ip adress lately,,.....Is there another addy I have been down the last 3 or 4 days.. Where do I find this on this site nano premium addys? Thanks Sam:tape:

[hutch]

it isn't a nano premium addy... it's a P$ addy... which P$ & port do you use???