Limesat hd air hello boot loop fix!!!

[Qch123]

I have a limesat HD air unit that often gave me the hello boot loop message once rebooted.
I decided to replace the power switch and power wire with one from an old viewsat ultra I had laying around and that seemed to have fixed the problem for me. I ran the unit for several days without powering off so it can run hot then powered off and on several times and now I don't get the boot loop anymore so if your unit gives you the boot loop try replacing the rear switch and maybe the power wire from another unit and see if that fixes the problem.

[fastrman]

Is this a known problem? Does it happen often? Just wondering because I was interested in this unit because of the positive feedback I have seen on it.

[Eddyx]

this is correct it as to do with the hard reset switch on the back of the unit

change the switch and it will fix the hello boot loop

look like the switch is really cheap or something ....

[karimou]

I changed the switch and the power cable I have always the same problem
lello loop 1 month ago

[elrasca]

I changed the switch and the power cable I have always the same problem
lello loop 1 month ago
Im having the same problem with my Limesat hd air.
Did you find a fix for it?

[marinerito]

same problem here ?

[coiphim]

It is still work with the hello boot loop. I wouldn't worry about that. If it really bother you, then replace it.

[Recove52]

Guide for BOOT LOOP fix
C?P from Webwizard...................1) Start the loader and set the com port.
2) Select file to you want to load.
3) While holding in the front panel power button reboot box and hold power
button on box in for at least 5 seconds while rebooting.
4) boot should freeze in display.
5) Press start on loader and file should begin transfer. When countdown is less
than 4 digits numbers are prefixed by letter A will appear.
6) When the display hits zero it should change to -E5-.
7) WAIT !!!! The Display on loader should be at 90% at this point.
8) The receiver should then start counting down prefixed with a "P". I assume
that is for 'PROGRAMMING'.
9) When the receiver displays -End- wait a few seconds, look at loader program
which should now be complete, and then reboot box.
(by WebWizard)
I have tested this method on 4 receivers and it works well.....

[kingbolt]

I had the same problem what I did is switch off by back switch but don't wait switch it back on right away in less than a second and it cleared mine working good ever since.

[karimou]

I use this method it shows me the end just BOOT
thanks

[whooper16]

ive had this issue for a week or so .i change power cord and rear switch still the same. so i start checking wires and one plug to the main board was loose.turns out that was the problem. no more hello boot loop. boots perfect every time.
thanks for all the useful posts