755donohoe
12-18-2012, 02:54 AM
Followed these steps but not working
You will see at the top of the screen... Network Local Setting...
DHCP....................turn it ON....
you should not have to put anything in there..
DHCP is Auto Find for you.....
click on apply. .. even if it disappears.. it come back again.. so don't panic....
exit out.... 1 time..
Arrow down to Server Setting...
Try going down to.. say... server 5.. and lets set it up...
Highlite and arrow to the right one time. that turns it ON..
Hit OK..
Protocol...................You want NewCamd
IP/Name..................
Port.........................
ID...........................
Pasword..................
DES Key..................
Highlite apply and hit ok
exit out 1 time..
at the bottom of the screen you see now... Where it shows all 8 possible server choices..
You will see at the top of the screen... Network Local Setting...
DHCP....................turn it ON....
you should not have to put anything in there..
DHCP is Auto Find for you.....
click on apply. .. even if it disappears.. it come back again.. so don't panic....
exit out.... 1 time..
Arrow down to Server Setting...
Try going down to.. say... server 5.. and lets set it up...
Highlite and arrow to the right one time. that turns it ON..
Hit OK..
Protocol...................You want NewCamd
IP/Name..................
Port.........................
ID...........................
Pasword..................
DES Key..................
Highlite apply and hit ok
exit out 1 time..
at the bottom of the screen you see now... Where it shows all 8 possible server choices..