tbird686
02-04-2013, 12:16 AM
so life was good for a while i had set the motor up a while back........2 nights ago it stopped moving to one of the satellites.....so i saw a dish transponder up date and did it then had to set up the motor again..
3 ways
1 - usuals
2 - manual...where you save it to the installer?
3- manual where you assign the sat a number...0-1-2-3-4-5
well # does not work the post is off alittle so i used the manual.......# i didn't assign the number just left it and it worked last night
its not working again right now....i'm trying to go between bev and dish and its not moving......i have to manually move it in the settings.......
why does it keep loosing it? i'll try a hard re boot but there really is no clear manual on how to set it up
3 ways
1 - usuals
2 - manual...where you save it to the installer?
3- manual where you assign the sat a number...0-1-2-3-4-5
well # does not work the post is off alittle so i used the manual.......# i didn't assign the number just left it and it worked last night
its not working again right now....i'm trying to go between bev and dish and its not moving......i have to manually move it in the settings.......
why does it keep loosing it? i'll try a hard re boot but there really is no clear manual on how to set it up