jynxbox switch

[digitalloss]

I am looking at getting a jynxbox. I have a dish pro. can I use it and setup another lnb for 129 and what would be the setup for switching?

[Terryl]

Diseqc #1=119, Diseqc #2=110, Diseqc #3= 129, but running that many DP LNB's off that receiver will cause a DC power shortage at the LNB's, the 3 LNB's will need at least 600 mA of DC current to run right.

It would be better to run a powered DPP44 switch, Port #1 = 119, port #2 = 110, port #3 = 129, port #4 can be used for 118 at a later date.

[digitalloss]

So It would probably be best to get a plus dish and a 44 switch?


Diseqc #1=119, Diseqc #2=110, Diseqc #3= 129, but running that many DP LNB's off that receiver will cause a DC power shortage at the LNB's, the 3 LNB's will need at least 600 mA of DC current to run right.

It would be better to run a powered DPP44 switch, Port #1 = 119, port #2 = 110, port #3 = 129, port #4 can be used for 118 at a later date.

[melvin5454]

you can use a dpp lnb and use a direct tv singial lnb and viptie it to the 119 side and run a short rg6 cable from it to the dpp in side and get 129 it will work i have it running rite now that way and you gont need a switch to use that set up

[dishuser]

you can use a dpp lnb and use a direct tv singial lnb and viptie it to the 119 side and run a short rg6 cable from it to the dpp in side and get 129 it will work i have it running rite now that way and you gont need a switch to use that set up

strange
have to try it
specs says it don't work with a legacy lnb

[bkr™]

you can use a dpp lnb and use a direct tv singial lnb and viptie it to the 119 side and run a short rg6 cable from it to the dpp in side and get 129 it will work i have it running rite now that way and you gont need a switch to use that set up

Did not know you could add a legacy type lnb to a dp plus lnb. Still there is the power drain on the stb.

[melvin5454]

i havnt noticed a power drain on my stb it just lose sigial for a second like i said that setup will work give it a try thank you will liuke just put the dtv lnb on port 3 and leave all switchs off on port 3 that what i did works good down in east tenn usa