no signal

[daemian]

hello everyone!
I have a sv360 elite that was working perfectly fine until the last two days where I've gotten the no signal screen.
I revised my settings.
In tuner 1 I have Strength 78 Quality 0.
In tuner 2 I have Strength 45 Quality 0.
My network status is connected. I already rebooted many times and the problem persists.
Can anybody help me with this problem?
Thank you. :bawl:

Tuner ID: Tuner 1
Satellite: EchoStar 8x
Connection: Loop-Through
LNB Type: OCS-DP
LNB Frequency: 11250
22 KHz: Off
LNB Power: On
Transponder: 12224
Search Option: All
Network Search: On
Diseqc: Port 1
Motor: Disable
Legacy Switch: Off

For Tuner 2 I have the same settings except that for Diseqc it says port 2.

[Sp0iler]

There is an issue with your Lnb.
Confirm the run to the dish is in good working order.
Confirm all connections are tight and weatherproof.
Confirm a good ground to the dish.
If you have any switches installed, by pass it and hook straight to the box to confirm a good or bad switch.
Last... replace the lnb.
Good luck,
Sp0iler

[daemian]

Thank you for your help. I will try that. :yes: