ricky1lung
03-04-2013, 06:28 PM
ok here is the deal i have an ultra and a pheonix both were working great then old switches started to bleed together had this happen before no biggie i know just buy a new switch replace the old one and your good right ... well you would think so but this is where my problem comes in ... i got 2 new switches and replaced them now these switches have 2.0 printed on them they seemed to work fine for a day then i would loose either 110 or 119 i just seem to depend on the box what sat it decided to grab so wondering what was going on i tried it over at a buddys house and the same thing started to happen there installed an sw21 everything works tried changing the lnbs i have square and my buddy has d shaped switched them from house to house and it seemed to mess with everything so lnbs back at original houses and only sw21 will work on each system im going to return the switches i got today and see if they have a different type to try i like to have 91 as well but cannot with sw21s has anyone else had this problem and were you able to fix it and if so how any insight would be greatly appreciated
thanks
1lung
thanks
1lung