Jynxbox only getting H tranponders in sky

[elcucuy]

So I found a nice 76cm dish on a yard sale and decided to put it to use with my jynxbox. I aimed at 58w on tranponder H 12000 and got around 77% of signal. After the scan I got 135 channels, I noticed that there was no signal on the verticals.

I messed around with the skew on the lnb, I would get signal on the vertical but now the horizontal transponders would be without signal. I tried with another lnb and it will be the same situation.

Has anyone have the same problem, could the jb200 not be working?

BTW I'm in LA

[Terryl]

Are you using a linear "legacy" LNB or a linear "standard" LNB?

And what settings are you using in the jynxbox for the LNB?

An old style legacy linear LNB will need two connections, one for the +13 volt output and one for the +18 volt output, these outputs can be run to a 22 Khz switch.

The standard linear LNB does not need the switch, but it still uses the +13 and +18 volts to switch between the polarity's of the transponders.

[elcucuy]

I'm using a standard lnb from flebay model ESX521FE.

On the Jynxbox ist set up as LO at 10750 with 22khz on.

[bkr™]

Read TerryL post above yours, no need for 22kHz on.
Make sure skew is set as per dishpointer.