A make 2 dream question

[rooster60]

This is gonna be a dumb question, but I will ask anyways.
Once I downloaded the make2dream file what is next to do?
I loaded the factory 106 and file 119 on my out of the box DL HD today.
Everything is good signal wise and sat scan.
Just the entering server information is nutty.
I had a SV 360 before disconnecting it. My code is still good for another 300 days and active.
Any help would be appreciated.

[Cassa]

fill out the Make2dream template with all the P$ info that was given to you. All the Make2dream file actually does is allow you to enter the info once, if right then just reapply whenever you require it. For example, whenever you do a system reset applying a new Bin, I apply the make2dream file, the channel file. All I have to do after that is define the sats on my diseqc and re-scan.
Saves the typing of the long numbers.

[rooster60]

I only have the 1 server for this receiver so I filled that out under Server 1 in the text file and saved it.
Then I ran the HD file and the CHNL LBD file came out.
What is next?
What goes into my USB stick?
And do I just simply load that into the receiver and it will know where its supposed to go?

[booter]

Just highlight and hit OK button on the CHLIST-S.LDB file that you put on your USB Stick which would have been created when you ran the make2dream program with your server info. The receiver will now have the server info installed.

Booter

[rooster60]

Thanks Booter I will do that.
I just don't want to mess up my new receiver as I just got it yesterday in the mail.
I only have one server to fill out.
Do I go to server 0 or server 1 and complete the respective field?
Also what do I put under server name? It asks for SERVER-ON-0

[rooster60]

Me bad.
I goofed on the DES key by one number.
Everything is good now.
My apologies to anyone for being annoying.