setting up a viewsat 9000hd with XFTA dongle and looking for setup files

[dtvbandit]

Can someone point me in the right direction where to find set up files for a my VS 9000HD I need the PFTAHDSW file and I need the XFTA file.

[StanW]

Can someone point me in the right direction where to find set up files for a my VS 9000HD I need the PFTAHDSW file and I need the XFTA file.
Look here : Viewsat Common files (http://www.satfix.net/forumdisplay.php?1224-Viewsat-Common-files)

[dtvbandit]

Thanks but the FTA dongle is already set up. I need the files that sets up the VS to communicate with the XFTA. In others the software you put in the VS pftahdsw ????. I'm replacing my VS as I was having trouble with it so I've got another reciever ready to go.


Look here : Viewsat Common files (http://www.satfix.net/forumdisplay.php?1224-Viewsat-Common-files)

[StanW]

We did a good job of hiding that forum :)

http://www.satfix.net/forumdisplay.php?1454-X-FTA-Router-Discussions

[got2bme]

for the VS 9000HD use the 110802H file posted here

http://www.satfix.net/showthread.php?119062-Pftahdsw-110802h&highlight=110802H

[dtvbandit]

Thats the file I used but still the VS and the XFTA aren't communicating. If I look at the serial setup it shows the 192.168.1.XXX and that its getting a signal from the router. When I try to set up the satellites there is signal but no quality. Meaning I can't tune any transponders in. Can't scan for transponders or nothing. Subscribed to a site as well. The old VS 9000 works but have been experiencing problems such as only being able to tune in one satellite at a time and then I have to reset and another will come in. I have some experimenting to do with the old one such as wiping it clean and reinstalling but wanted to get the other new receiver working first. Is there a file that will allow to communicate with the xfta and the VS?


for the VS 9000HD use the 110802H file posted here

http://www.satfix.net/showthread.php?119062-Pftahdsw-110802h&highlight=110802H