PDA

View Full Version : N Fusion receiver lock



Ric551
04-15-2013, 01:25 AM
With all the rebooting and stuff going on to try and keep things working my receiver locked up on Ch 9460...I,ve unplug ,rebooted, several times but it will not switch off 9460 channel..Any suggestions ..... If I do a "factory default" will I have to reload everything? like r25 bin and all network settings ..
running 110,119,129

clarkie
04-15-2013, 02:20 AM
You will have to load all PS setting, and rescan etc..load the latest factory file and then r25 if that is what you have now.. dont forget to write down all your info before hand

tbird686
04-15-2013, 02:39 AM
you should run the r27 for those sats unless your running bev as well

Ric551
04-15-2013, 02:12 PM
I got it unlocked..by pressing the Sat button on the remote and then unchecked all Sats to one of the other Sats listed and then it switched , after I got it to change channels I pressed Sat button again and checked " All Sats" again. then everything was back to normal! not sure why my recv'r would do that.. It's all good ,, just wish the servers were more stable!!:yes: ... thanks guys!!

gwrowe
04-16-2013, 04:36 AM
FYI Guy's! If you ever have to do a fact default, the only info you will loose is the gateway in the network, and your sat settings, also you will have to reset time and language etc., and have to set network back to static, all your PS info is in the NOI!!

clarkie
04-16-2013, 12:51 PM
I c that THanks button must be broken again...if you what/need help thank a few of the people taking the time to help...or figure it out on your own....spoon feeding times are over and a lot of visiting digs all feel the same...:okay:

steveng01
04-16-2013, 02:07 PM
hey guys whats the latest factory file to setup for ps?

Sam Crow
04-16-2013, 02:51 PM
FYI Guy's! If you ever have to do a fact default, the only info you will loose is the gateway in the network, and your sat settings, also you will have to reset time and language etc., and have to set network back to static, all your PS info is in the NOI!!



Yes this is what I have to do every time I have done a Factory Reset also!! Great Post!!