DreamLink HD V4, HD board

[aldofoto]

I just bought a DreamLink HD V4 from worldwidesatellite, but I don't get any HD channels. I saw in some posts in here people talking about some HD board. Do I have to install the HD board on my receiver, or its already installed because the company where I bought it said its HD. Help please.

[KIDWCKED]

Prolly came with sd def board installed...You need to install Hd board...Heres a pic that might help you..




http://i1015.photobucket.com/albums/af275/toddr1/boardin.jpg (http://s1015.photobucket.com/user/toddr1/media/boardin.jpg.html)





http://i1015.photobucket.com/albums/af275/toddr1/arrows.jpg (http://s1015.photobucket.com/user/toddr1/media/arrows.jpg.html)

[aldofoto]

Thanks for the help.
so the red chip is the HD board, right? If it doesn't came with it, how much does it cost to buy it?

[KIDWCKED]

It could be either red/green...If it didn't come with the reciever...Yes you will need it....For HD viewing....Maybe contact the supplier you mentioned....For the board...

[aldofoto]

I just checked it, it has a green one but I'm not sure if its either HD or SD

[KIDWCKED]

I just checked it, it has a green one but I'm not sure if its either HD or SD

Most likely sd....;).......Jmo....

[aldofoto]

DVB-S Demond Rev2.1

that's what's written on it. Does it says anything?

[KIDWCKED]

DVB-S Demond Rev2.1

that's what's written on it. Does it says anything?

I am not sure what the HD boards are selling for....But you will need one.....sk200...........

[torpainter]

worldwide does not sell them with the board installed.Did it come with a lttle piece of rubber? Thats the heatsink

[aceallenk]

DVB-S Demond Rev2.1

that's what's written on it. Does it says anything?

That is the original SD module. You'll need the SK-200 module and then install it. I purchased my module from Ebay and most already have the heatsink already attached, ( glued on). I don't think I can post a link for that on open forum so if I find my link I'll send you a PM. Both my receivers been working perfectly for 9 months with these module.

[aldofoto]

I have the heatsink and the HD module. What do I have to do with the heatsink???

[aldofoto]

I glued the heahsink that came with the box with module. Whats the next step after installing the hd module. Im trying to scan for channels and the S and Q is 90% no matter where the dish is. Im assuming is something wrong with the set up. Do I have to do a factory reset after installing the HD molule?

[dishuser]

I have the heatsink and the HD module. What do I have to do with the heatsink???
the heatsink will stick to the board

[aldofoto]

ok it did. After installing the module do I have to load the factory files again?

[dishuser]

load 1.06 and default the load 1.19 and default then setup and scan

[arflaw]

http://i1229.photobucket.com/albums/ee471/arflaw/Satellite/dreamlink/DSC00960.jpg (http://s1229.photobucket.com/user/arflaw/media/Satellite/dreamlink/DSC00960.jpg.html)

Board color can be green or red.

[BIGbLUEbOLAS]

is this box any better than the older one? sorry for highjack

[torpainter]

is this box any better than the older one? sorry for highjack

there has only been one modification of the dreamlink since it was released