adelagza
05-01-2013, 06:19 AM
Hi, I just bought a Jynxbox STB and so far I have not been able to configure it out, I placed the Firmware 239 and after I did my Factory reset, then I tried to scan the channels of the three LNB's I have for 110, 119 and 129 so far I have not been able to load a single channel, I have an antena mediun size which I used for a Sonicview 8000 which went dead but it worked all right with the antenna!! when I do the real thing with the activation number and the rest of the stuff which I belive I am loading right after everything is loaded and I go to APPLY it comes out the window CONNECTION FAILED!! can someone ilustrate me what am I doing wrong that even the STB does not recognize the activation parameters??? I want to thank in advance to all those that might take interest in my problem, perhaps with all your help we might start this little monster - THANKS -
P.S. I am usinf the Jynx WiFi and it loads OK and I get a signal of S and Q of 99 but so far that all is OK, the rest Who knows??
P.S. I am usinf the Jynx WiFi and it loads OK and I get a signal of S and Q of 99 but so far that all is OK, the rest Who knows??