problem with limesat hd air

[jennygirl22]

I have a limesat hd air. When I hook up 91, 110 and 119. the 119 does get good quality and only two transponders seem to connect, however, if I hook the same set up to my limesat ultra the feed and quality are excellent without issue. So this is simply changing the hookups from one receiver to the other. At first I tried a new switch with the hd air and thought that was the issue but not. I tried a new lnb and still not the issue. so not sure what the problem is. But it must be in the receiver itself. Any help would be appreciated.

[hot10977]

Hello Jenny

I'm new to this site and i have a Limesat HD AIR and Dish pro HD from dish network. i don't how how to make it work so

1st. how do you point your dish in what direction i hear 110,119 and 129 i have no idea what this is

2. how do you set up the receiver

3. the receiver is blank i tried to auto scan and nothing

[kaffka]

Hello

have you tried to scan, even if the signal/quality is not good?

Mine did the same, i was at 30% but when I scanned it, i got some transponder at 97%. (i knew i was right on it)

[Recove52]

remove the cover look at the green or red board you will see destiny 2.0 or 2.1 or 2.2 ,2.3,,the 2.0 are the version one LS Air the destiny 2 are the 2.1 or 2.2 2.3 ,,the version one uses the 130 bin, the version 2 uses the 131 bin either load the appropiate bin with the Limesat loader and a null cable with your PC or use a USB either way the file must be extracted if it is a RAR file or unzipped if you use a zip file , now when you have the cover removed you will need to either seat the LS400 or 500 HD Card if it has not been seated in the receiver when purchased. then enter sat settup enter the appropiate info for your sats ,,use TP 12516 to get the best S & Q possible for your sat settup. scan each sat seperately use sats 110 119 129 and only setup for bev if you live along the canadian border or in canada as you will not get bev otherwise..you will only get some tp,s when scanning 119 as only some are available, the 110 has some HD but most are on 129 sat, you will not get 129 with a dual LNB setup only 110 an 119.once you do all of the above . go to your network server setup and enter your server info once all is done exit out to a working ch. such as 200 give it a moment and you should roll in..Hope this Helps

[jennygirl22]

finally resolved the issue and it turned out to be a loose connection between the coax wire and the connector on the end of the coax cable. I guess the connections was moving around each time i would change from one receiver to the other. Once we changed the connector end and made sure it was secure, the problem was resolved.