Help with new beaver sub

[hellracer]

Hi,

I have nfusion HD. SO far I got a dual sub N+S.

SO far South work well 110-119. However I have nothing with north only sound on the 82. With NOI i can see I can connect to server but channel is #red mean it doesnt get the key.

Is anything special in the setting? Of course i have reboot few times...

________

thanks for your tips.

[dishuser]

did you pay for both?

[thebeav]

yes he has both and server running good so i think either noi set up wrong witch im no help with as im not familiar with noi or maybe a rescan of sats may help

[hellracer]

Just did rescan, nothing new, strangely on the 82 i get sound and channel swithc is very fast but black screen.

[dishuser]

Just did rescan, nothing new, strangely on the 82 i get sound and channel swithc is very fast but black screen.

audio isn't encrypted

[thebeav]

ok so sat pointed fine u did notice north and south logins are different for user and pass and port

u are not currently connected to north server so i would say double check all info and maybe even shut south off well u try north to rule out it trying to grab from wrong server

[hellracer]

OK, Rignt now, my setup is for North only.

From NOI main panel is see <server1> in green that mean I<m connected to the server. But thats all. I see the <snow anymation' that mean it doesnt decrypt the chanel.

COuld it be a setting in the box for that?

(I can see the standard EPG, and signal is 100%)
(Yes 2 different logins)

[thebeav]

u just connected to server but did not request a control word so it is something in noi or in the nfusion im relay not familiar with tese setups so hope someone can maybe jump in and help you

but we now know u are connecting just not sending the data needed to the server for it to reply with the control word

[StanW]

Which file are you using on the nfhd ?

[hellracer]

not certain exactly what you mean by file, but from what i know in the info section

boot 1.05

sw 1.3sr 27F

america

NOI 1.31a

1 month ago I have used a file for chanel name , file similar to <Nfhd_update_119-110-129_27f_3-10-13<


____________________

update: OK, after a it of reading it seem that my 27F does only work with South. I need to swap to either 24F or 25F. I tried to find it but so far if someone would point out the needed file or a link I would really appreciated it.

Should I look for 24 or 25F, any better?

Can i just install the bin over the current 27F without any problem?

Also i have added IP 210.51.47.147, do I need another one for Bev?

thanks

[kikid]

Yup the 27f is only used for south.. If you want both you have to go with 25F file.. And make sure you do the network wizard once that file is loaded good luck :)

[dandaling]

Also the different Software versions may carry a different Suns IP address, you will need to Match the IP for that software in your TCP/IP configuration in your NOI PC when you add a virtual IP.
I can't remember what the IPs are. If you are technical, you could detect the destination IP through your router logs. (that is if you set the receiver Gateway IP to the router's IP address.) The Fun of setting up NOI, especially if you are non-technical (then God help you).
Good Luck!