Signal loss switching from sat 129 to 110-119 Problem

[chrisg1]

I am experiencing signal loss when switching to a channel on 110 or 119 from a channel on 129. It is random but also happens when switching between channels that have the same transponder frequency on both 110-129 or 119-129.

For example transponder 22 on 110 is 12530MHz Horizontal TURBO 8PSK and transponder 22 on 129 is also 12530MHz Horizontal TURBO 8PSK.
So for example you are on channel 9468 Speed on 129 then switch to channel 9525 H2 on 110 which has the same tp frequency as 129 the signal and quality will drop out on the Dreamlink and channel will not come on.

Entering and scrolling through and exiting the menu multiple times eventually causes the Dreamlink to detect 110 again with signal and channel coming back.
It also happens randomly between different transponders and HD SD channels, so its hard to troubleshoot and narrow down what the problem could be.

Again this problem only happens when switching to a channel on 110-119 from a channel on 129.

I am using 3 standard circular lnbs going into a DMS International 4x1 DISEqC switch with 119 on port 1, 110 on port 2, and 129 on port 3
LNB Type is set to Single, Power On, Frequency 11.250

I have green SK200 module and HD channels are pixelated when box is first turned on and randomly during viewing. SK200 module or connectors on board could be damaged which is causing the signal loss but switching between channels on 110-119 are fine.

Any Ideas ?

[whoknows]

You could try a 4x1 Chieta Heavy Duty Diseqc Switch WSD-2041 and see if that cures your problem. good luck

[chrisg1]

Thanks, problem was a bad green sk200 module and Diseqc Switch. Got a new Red sk200 module and new switch, problem is solved.
I might look into getting a Chieta Heavy Duty Diseqc Switch too. Thanks