Old Timer Reaaly Needs Help

[JimmyB9]

I have an nFusion HD that I would like to get up and running.
I have a Linksys WRT54G router that I would like to hook up to it rather than having to run a PC all the time.
Do I need to replace the factory bin (v1.3sR27F) if so where do I get it.
Do I need an NOI file, if so which one, where do I get it and how do I load it?
After that what do I do?

I already subscribe to a private server and am replacing my Nano2 (converted to I-Link) as it has bit the dust.

Be gentle, I'm old.
Thanx
Jim

[StanW]

There are at least 3 way of connecting a nfhd to a p$ . You will have to decide which one meets your requirements the best and than follow the installation instruction that it calls for.

[goofather]

I have an nFusion HD that I would like to get up and running.
I have a Linksys WRT54G router that I would like to hook up to it rather than having to run a PC all the time.
Do I need to replace the factory bin (v1.3sR27F) if so where do I get it.
Do I need an NOI file, if so which one, where do I get it and how do I load it?
After that what do I do?

I already subscribe to a private server and am replacing my Nano2 (converted to I-Link) as it has bit the dust.

Be gentle, I'm old.
Thanx
Jim

You just need the last officially released bin from nfusion. Which is r27 for the HD. You can use 24 or 25 if you want to receive both North and South. r27 gets South only.

dd-wr-goo is compatible with all Linksys WRT54g routers, versions 1 through 8. Just refer to the dd-wrt website for flashing instructions for you particular version of WRT54g.

[JimmyB9]

OK. I want both birds, so where do I get 24f and how do I put it in?

[goofather]

Should be here in the files section...nf_hd_v1.3sR_25

If you flashed your receiver with 27, same procedure to put 25 on.

[JimmyB9]

OK. I put 24 on successfully. Now what do I do.

BTW Thanks very much for helping me.

Jim

[JimmyB9]

Sorry I meant I put 25 on successfully.
Jim

[henpecked]

Taking for granted that you're all hooked up to north and south dishes..
Go into installation and set up your sats/lnbs and scan channels

[JimmyB9]

OK. That's done.
Where do I enter my P$ info?

[henpecked]

You'll have to change the firmware on your router..to dd-wrt
Go here and input model of your router...read everything carefully...don't take short cuts


http://www.dd-wrt.com/site/support/router-database

Once that's done..you're home free ...there is a bin put out by goofather to input PS servers
called dd-wr-goo.v24_micro_generic-2.bin




OK. That's done.
Where do I enter my P$ info?

[henpecked]

Old timer..you give up?

[StanW]

Old timer..you give up?
Show some respect sonny - he might be taking a nap ;)

[henpecked]

I'm sure I might be as old as him
I don't need a nap:)


Show some respect sonny - he might be taking a nap ;)