limesat air v1

[patton1962]

gentlemen my limesat air v1 just went out , please don't tell me to load up the file with a null cable this is not the problem the reason I know is I have two units and I switch parts around between the two and the probem is the power supply board , does any one of you know what part to change on the board resistors ,transistors like the old days with the sonicview power boards please any one out there

[scsa1000]

I heard if you had a nano 2 it uses the same power supply however I am not sure. I am in the same boat as you I just want to buy a new power supply the white end connector with the actual plug to the wall. Mine the wires are actually cut almost all out so it doesn't work well at all.

[patton1962]

Limesat air hd power board back to life19125Well it took me a few days to identified the bad connection, I have two of the same receivers and I swap the power supply between the two and that is how I found out the power supply was bad in one of them , on the bad p supply I was able to tell becouse I noticed a slight yellow stain (over heatting)under the board where the diode sat on I remove the diode of the good board and place it on the bad one, and the receiver turn on, the diode I removed from the bad one just for the hell of it I put it back on the good board and it worked , so the only explanation left is the diode was not sitting properly on board and that gave it a false connection. as all of you know this receivers are poorly made