PDA

View Full Version : Problem getting codes to work on VS9000



RMAC11
08-04-2013, 03:43 PM
Hello everyone, I just got my setup (XFTA ROUTER) & have been working all day & nite to get it going (using a VS9000)... Setting up the router went pretty smooth (getting all the right indications) but it says failed to re-connect to card server. Heres my log :

RECEIVER **** [Sat Aug 3 22:35:27 2013] | Processing packet...
Message Type: ECM | CaID: 1816 | Provider: FFFFFFFF | Video PID: 1422
SID: 0200 | Sequence: 000290

ECM Data:
80 30 8F 07 8D E7 34 20 56 8D 9B 6A D5 1B 7A 26
DD A4 53 89 81 70 C7 C1 4F 5A 71 6A AC 9A 1C 15
71 7E 08 42 5C 80 6C AB 84 08 59 7D 01 06 87 21
1F FD 79 30 C8 0A 87 FF 97 E1 81 B5 80 C1 07 AB
23 68 3D 74 FB AE B3 27 F3 EF 97 30 E2 73 2A 4F
72 61 A7 5E 94 F5 C2 E2 46 E9 B7 D8 41 2F 53 E2
49 71 15 EB C4 81 2D DA 93 4C FA 04 5F AB E2 EF
48 9F 1C DF 0F CD 1D 45 63 BA 1F CA 53 6A 36 7F
ED C3 D6 4B 0E FA 88 C3 97 33 71 41 61 2F 11 DF
CB 88

Trying: newcamd://xxxxx2314959:[email protected] ...
Trying: newcamd://xxxxx2314959:[email protected] ...
Failed to reconnect to card server.

Heres the info they sent me:

User & pass : xxxxx2314959 SERVER: 2.rocketserver.tv PORT: 35922 DESKEY: xxxx xxxx 4540 6970 9871 2341 2134
I emailed my PS & told him the problem & he sent me this(103.31.187.125 ) to use in place of (2.rocketserver.tv ) & still NO GO !

Any ideas what I may doing wrong ??

in the menu on my VS9000, its reporting everything correct:
network setting DHCP
IP address:192.168.1.130
Subnet Mask: 255.255.255.0
Default Gateway:192.168.1.1
DNS 1 :8.8.4.4
DNS 2 :8.8.8.8

Network S/W upgrade
New Software : DX-X00-N APP 200.19

This is all the info I can think of to give you guys !! Anyone have a vs9000 WORKING ??

Thanks :helpsmilie:

RMAC11
08-07-2013, 11:29 PM
PROBLEM SOLVED !! HERE'S WHAT I DID ...this makes no since to me but after about the 10th time doing everything from scratch, all I did was while doing the initial setup & still connected to my labtop via cat5 cable(lan connection), I just simply did a hard re-boot & went back into
Gargoyle( while still connected to labtop), checked my logs & VOLA...... CONNECTED !!! Took XFTA back to my VS 9000 & channels popped right in.
Makes no since but it works both WIRED & WIRELESS...GO FIGURE.

Thanks Again !