JynxBox Ultra HD V3 & DN 1000+ Antenna

[Batman]

Just in the middle of setting up my newly bought JynxBox. I literally just switched out my current vip222k with the Jynxbox and keeping the Dish 1000+ (110, 119, 118 and 129) dpp44 switch. Been trying the auto scan, but it kept skipping TP. Any suggestion on the correct way to set it up?

Your two cents are appreciated!

[Fibroso]

Use diseqc1 2 3 4, fix your settings remember any dp is like a big diseqc. Set you lnb ocs-dp make sure you have s and q.

[genmax]

Set your Jynxbox on the PORT 2 of yoru DP44 Switch.
Plug in your POWER INSERTER on PORT 1.

In your jynxbox go into settings and turn off LNB power. ( Not needed as your power inserterer pumps our more then enough power.)
Then set LNB Switch to OCS-DP and the usual Diseqc's.

The jynbox acts weird if you have it on the same line as your power inserter, once you do the swaps i mentioned above it works flawlessly.

[Batman]

Is it normal that it skips transponders? Also, when I played around the Diseq switch port, it seems that the box randomly assigns signal to any port. Sometimes port 1 has singal on 110 and after I switched, port 3 might be the one has signal. Does it matter?