I-Link 9800 hd se problem

[lwv30]

Hi everyone . Im new and need help. I turn on my box " I-link 9800 hd SE " and a message comes out and it says ASH in the box and it doesn't turn on. Can somebody help me with this . I will appreciate your help. Thanks

[playboystylie]

Hey im having the same problem... Is there anybody who can assist

[bigstick]

hey guys having same problem

[swanner]

follow steps to reload files... factory and latest files... rescan birds etc...

might have to load factory file onto usb stick, then insert into unit and switch on from back... wait for a booting screen if it comes up,

then proceed with the file updates..

goodluck

[bigstick]

is there a factory file for the 9800se

[bigstick]

I haven't seen a factory file for the 9800se

[techno]

its in the menu on the box,when u load it ,it will erase all your info just reload your bin and your server info ,then use auto disec,make sure u have signal on 110,119,129, then do a reg scan are press blue button,channels will be added and the epg ,use the 1000.2 dish,ONLY no switch that should do it

[Bgerstel]

Can not see display need to use loader

[Bgerstel]

Update for those of you who are experiencing an ASH error, use the Jynbox Ultra HD loader with a rs232 cable. Double click "All Chunk" and locate the factory file I-Link IS-9800 HD (Factory File) Mar.20.2013 and click next. Once done the ASH error should be done with. However, you wont be able to use the remote, so once again, load the latest FTA Fix File I-Link IS-9800 HD File Sep.10.2013 via rs232 cable and Jynbox Ultra HD loader.

Once completed, setup the stb as usual with sat settings and p$. Good Luck! Bgerstel