Ethernet Connection

[whiteheather]

I seem to be having an issue with setting up my jynxbox hd ver 3. it has been determined this is an original box. Q1 I did have a nano 2 and put all info in on the new box. I am on echo star 10/11, it seems I have everything ok, even have scanned satelitte and have 8- to 85% signal. do have EPG but no picture. the cat 5 at the rear does not light up when installed. could this be the problem. I do have the cat 5 from the router directly to receiver, if anyone is on Skype and would be willing to assist I would be grateful. you can pm me if posssible....this getting old is the pits....many thanks....W/H

[bkr™]

There are no lights on the ethernet connector, go to menu -> tools -> network local setting -> DHCP ON. Should populate w/ ip addy, subnet mask, gateway all in blue/grey. Go to apply, hit OK on remote.

[whiteheather]

There are no lights on the ethernet connector, go to menu -> tools -> network local setting -> DHCP ON. Should populate w/ ip addy, subnet mask, gateway all in blue/grey. Go to apply, hit OK on remote.

sadly that didnt work. i have contacted supplier and returning for replacement..many thanks....charlie

[whiteheather]

is there anyone in the pacific northwest who is on echo 10/11 and has jynxbox hd that can help, waiting on replacement receiver..many thanks.................charlie

[Terryl]

You didn't by accident use or pick up a cross over CAT5 cable did you??

[Anubis]

I would've tried a new cat5 cable in a different port from the router before returning it. Sounds like either that or your router firewall is blocking you. I have not seen an issue with the LAN port on the unit but it is possible.

[whiteheather]

thanks guy's, i did change cat cable tried direct port, still nothing...supplier has no hesitation in replacing. not a cross over.......

i did re connect my old nano and ethernet worked perfect, used same cables as with jynxbox....................