Jynxbox ultra HD lite

[kingbolt]

Is there any one else who is only getting 228 channels on 119 sat

[Fastcompany]

Could be the switch you are using. The Jynxbox (Ultra at least) do not like the SW series switches.

[holly2012]

Could be your antenna settings post them and let us see what they look like and make sure they are correct

[AeonFlux]

Delete all the channels and do a TP-by-TP manual scan. It sounds worse than it is. Takes a little time but I get excellent results every time. Jynx has a terrible auto scan routine.

On your dish setup screen for 119 hit the blue button to scan TP.
Start at the 1st TP. Wait a second to see if you get good signal. If spot beam TP then maybe you not get it. If you not get good signal move to the next TP.
When you get good signal colored bars then hit the blue button and a screen will pop up. I usually set network=off. It will hold this setting so you only need to do this once.
Then hit OK to scan.
When it finishes, hit OK to save.
Do next TP same way until you got them all scanned.

[Bob Loblaw]

If you have DP LNBs set the Legacy LNB to OCS-DP