PDA

View Full Version : Can load factory but can't load firmware versions



dottore
11-15-2013, 05:34 PM
Can't use USB because remote doesn't work at all.

When I try using the loader for the firmware versions I get an error stating too small a chunk size.

Can anyone help me with this?

Thanks in advance.

Anubis
11-15-2013, 07:20 PM
Follow loader instructions found here...http://www.satfix.net/showthread.php?123251-How-to-use-the-loader-PDF and make sure the file is unrared. You only need file 035.

dottore
11-15-2013, 07:35 PM
Thanks for the reply but how to I get the original factory bin off the receiver first?

Anubis
11-15-2013, 07:49 PM
You leave it on. Simply load the 035 file over it then factory default.

altupi
11-16-2013, 01:36 AM
Hi everyone, I have the same problem. I bought the HD ultra lite and the remote does not work, when I use the loader V02 it's posibble to load the factory file v6 but I can't load any other bin I've this error: "bootloader or maincode version not compatible" when I load with all chunk ......and if I try with firmware I've this error: "select file larger than slave chunk size ¨.
Any idea to help me.
thanks

dustdogger
11-16-2013, 01:49 AM
Follow loader instructions found here and make sure the file is unrared. You only need file 035.

you say follow loader instructions found here, but I can't find them. :noidea:

I get same message as altupi when I try to load v034, however, I can load v035 but I still get no response from the remote after I load this bin. I have the remote on the right in the picture.

Bob Loblaw
11-16-2013, 04:07 PM
Use this file http://www.satfix.net/showthread.php?145714-Jynxbox-035-with-all-chunks-included&p=1014462#post1014462 and load it like a factory file and you will be good to go.
This is not an official file from Jynxbox

Anubis
11-16-2013, 05:13 PM
you say follow loader instructions found here, but I can't find them. :noidea:

I get same message as altupi when I try to load v034, however, I can load v035 but I still get no response from the remote after I load this bin. I have the remote on the right in the picture.
I added the link to my original post. For some reason it did not post. I'll blame it on computer error even though it was human.:D

Use this file http://www.satfix.net/showthread.php?145714-Jynxbox-035-with-all-chunks-included&p=1014462#post1014462 and load it like a factory file and you will be good to go.
This is not an official file from Jynxbox
Care to explain this file?

Bob Loblaw
11-16-2013, 06:20 PM
I sent you a PM regarding this file