rusty44
12-21-2013, 05:29 PM
The 360 was working good. on 12-4-13 I suffered a computer melt down. I have restored my computer. My sv8000 works great on the same computer. but I cannot get the 360 P working again.
I have WIZnet 3.02 and my dongle version shows 4.12 on port 1920.
My 360 P receiver shows Boot loader 1.00 and usb loader 1.00 and firmware P28
I have done factory reset. & rinstalled file 28-2028. When I turn receiver on it shows network adp. connected. But no picture, then I go to network settings and it shows connection fail.
I also hard wired from modum to dongle w/new cat5 cable. eleminiting Homeplugwave system.
I need help.
I have WIZnet 3.02 and my dongle version shows 4.12 on port 1920.
My 360 P receiver shows Boot loader 1.00 and usb loader 1.00 and firmware P28
I have done factory reset. & rinstalled file 28-2028. When I turn receiver on it shows network adp. connected. But no picture, then I go to network settings and it shows connection fail.
I also hard wired from modum to dongle w/new cat5 cable. eleminiting Homeplugwave system.
I need help.