help needed please

[akash ahmed]

My ultras display showing 0000 after reboot.It has bootloop and I forced downloaded factory file 103 and201.i also loaded bin 273 and 275.What to do now?experts please help.Thanks in advance.

[KIDWCKED]

if this dont work...then place the box behind ur car and back over it...
Guide to fix BOOT LOOP (http://www.satfix.net/showthread.php?130929-Guide-to-fix-BOOT-LOOP)

[future]

My ultras display showing 0000 after reboot.It has bootloop and I forced downloaded factory file 103 and201.i also loaded bin 273 and 275.What to do now?experts please help.Thanks in advance.


If disconnecting the Power for 1/2 an hour doesn't work for you --------try this method.

Force Loading Limesat Ultra Factory V 1.03 Bin File.


1) Start the loader and set the com port.

2) Select file you want to load.------Factory v1.03

3) While holding in the front panel power button ----- reboot box and hold front power
button on box in for at least 5 seconds while rebooting.

4) boot should freeze in display.

5) Press start on loader and file should begin transfer. When countdown is less
than 4 digits numbers are prefixed by letter A will appear.

6) When the display hits zero it should change to -E5-.

7) WAIT !!!! The Display on loader should be at 90% at this point.

8) The receiver should then start counting down prefixed with a "P". I assume
that is for 'PROGRAMMING'.

9) When the receiver displays -End- wait a few seconds, look at loader program
which should now be complete, and then reboot box.

(by WebWizard)

Credit goes to setwire

[akash ahmed]

I followed those steps and that's how I am getting 0000 in the monitor.Previously it was BOOT in the monitor.Transfer of the file 103 and 273 was smooth and I was hoping box will work,but it didn't.Now it fixes with 0000.Dont know what to do.Thanks.

[whoknows]

It's going to say 0000 until you scan some channels to it and set the time. Don't forget to hit the "on" button.