need help with boot loop

[max360]

my limesat ultra goes in to a boot loop when i put in file 2.75
I load the factory 103 with the computer and it boots up. What file do I need to load next to get it to work?
i have a v1
do i need to load 2.73 first then 2.74 then 2.75?

[future]

my limesat ultra goes in to a boot loop when i put in file 2.75
I load the factory 103 with the computer and it boots up. What file do I need to load next to get it to work?
i have a v2
do i need to load 2.73 first then 2.74 then 2.75?
Try the below steps then load the latest file.
If disconnecting the Power for 1/2 an hour doesn't work for you --------try this method.

Force Loading Limesat Ultra Factory V 1.03 Bin File.


1) Start the loader and set the com port.

2) Select file you want to load.------Factory v1.03

3) While holding in the front panel power button ----- reboot box and hold front power
button on box in for at least 5 seconds while rebooting.

4) boot should freeze in display.

5) Press start on loader and file should begin transfer. When countdown is less
than 4 digits numbers are prefixed by letter A will appear.

6) When the display hits zero it should change to -E5-.

7) WAIT !!!! The Display on loader should be at 90% at this point.

8) The receiver should then start counting down prefixed with a "P". I assume
that is for 'PROGRAMMING'.

9) When the receiver displays -End- wait a few seconds, look at loader program
which should now be complete, and then reboot box.

(by WebWizard)

Credit goes to setwire

[max360]

Force loading 103 works. Every code I try 273and 275 put it back in to the boot loop. (It says boot for 30 seconds then goes to the colon and a red light with no display on TV. The only button that works then is the power on the back)

[Deadman]

Try undoing the sat cable while its powered on, then power off and on then off again and put the sat cable back on and power it up,

[max360]

I tried with sat cable off and with only the power still gets stuck

[Nostradamus]

Try undoing the sat cable while its powered on, then power off and on then off again and put the sat cable back on and power it up,

where did you come up with that gem?

YOU SHOULD NEVER DISCONNECT CABLE WITH RECEIVER ON! unless you like buying new switches

[Recove52]

load the 103,then do a hardboot, then load the 201,,hardboot then load the 2.73 ,,,setup your sats and scan ,,then enter your network and server info save each line as you enter it useing the green button ,,once all has been entered and saved initiate the server with the blue button ...exit out once you see caid connect ..put on channel 342 for a few ,,you should roll in pretty quickly...

[future]

Try undoing the sat cable while its powered on, then power off and on then off again and put the sat cable back on and power it up,

In my opinion if you unplug the cable and re plug it from the receiver while it's on this might cause you in burning your lnb so my advice to you if you are going to unplug the sat cable from your receiver then make sure you have your receiver turned of from the back switch first.