cannot get 82,nimmiq4 in???

[marcelect]

Ihave lost the touch with my 9000hd because some of you knows that Iwas sick in the hospital last year.Ihave 2 of them out of 3 working with x fta but I cannot get the 82 in.Iremember someone here gave instruction about that by deleting the tp's that has no quality then search for them.IF SOMEONE CAN HELP,MY HEAD STILL WORKS GOOD.THANK YOU
PS:iGET THE SIGNAL WITH LIMESAT HD AIR SO NOT THE LNB/WIRE/ETC...:thumbsup:

[bruinfan]

In antenna set up, save the first quality t/p frequency you find then do this:


SpotBeam Scan.....

In antenna setup turn lnb power off to all sats except the one you wish to scan, then go to channel scan section in menu, make sure network is on. Select the sat you want to scan, go down to search edit t/p... hit ok this will highlight one of the t/p's...scroll down to the first t/p with quality, delete all other t/p's...each sat like I said is done separately. (delete is F3 button on remote)... after deleting all t/p's minus the spot beam transponder hit ok. This will search for all t/p's and ch on that sat... after done scanning save.... do this for all the sats you want to scan .... Remember to turn lnb power back ON in antenna setup for all the sats, after you are done scanning. Every few weeks I'll scan but don't always turn off the other LNB's and works just as good.

[marcelect]

thanks bruinfan.I DID THAT BEFORE AND WORKED FINE.LOST MY NOTE.I WROTE IT again in case of.I am going to do that right now.Thank you bud.