New dreamlink t5 help

[roper7]

I have a new T5 Dreamlink I tried to scan auto and manuel channels nothing is appearing on the screen
need your help

[Longster]

I have a new T5 Dreamlink I tried to scan auto and manuel channels nothing is appearing on the screen
need your help
Did you set up the right lnb and switches for the right satellit?

[whoknows]

You want help but leave no information. Post what dish you are using along with your antenna settings.

[roper7]

You want help but leave no information. Post what dish you are using along with your antenna settings.
I have a Dish 1000.2 turbo HD full Satellite kit 110,119,129

Plus useing DISEQC MOTOR Model SG6100

Should I setup without the Motor first or with the Motor. is there anyone that can help in setting up the satellite system what settings do I use? I have a signal finder and compass what else do I need. I live in Fla

[aidejr]

A 1000.2 dish on a Motor? That dish is designed to get 3 sats 110 119 129 not the darn arc so whats the point of motor.

LNB type OCS-DP
119 port 1
110 port 2
129 port 3

[Dzaster]

The 1000.2 dish stays stationary. So do not use the motor. Are you going to be hooking up just the receiver? You will need more power to power up the lnbs. If you go to dishpointer.com and put in your location and select your sat and lnb it will get you close. Make sure to set your mast plumb and level and secure before setting the dish on. You can add a power inserter to port 1 on the lnb or add another receiver dn or fta to the lnb to help power up. Once the dish is in place you can connect the receiver and start moving it to dial it in. don't forget to ground the dish

119 port 1 frequency 11250 ocs-dp
110 port 2 frequency 11250 ocs-dp
129 port 3 frequency 11250 ocs-dp

make sure the bars on the signal and quality meter are blue, if they are red that indicates an issue. Bad setting or not enough power. Post back where your at and Im sure you can get the help you need.

[roper7]

Thank you Iam going to remove the motor, and let you know.

[torpainter]

Thank you Iam going to remove the motor, and let you know.

as stated you will need more power to run the lnbs Get a power inserter

[dslchome]

as stated you will need more power to run the lnbs Get a power inserter


That is why I love the DISH 1000 Pro

110 119 118 129

I have 2 DP44 switches ( Grouding block editions ) and 2 Power inserters

by far the best DISH and easy.....

I used to like DISH 500s and for a novice the DISH 500 might be the most easy for 110 119
but Once you use a DISH 1000 Plus you will not want anything else.

[roper7]

What kind of Power Inserter do buy

[Dzaster]

you will need a dpplus power inserter

[Brad8291]

I used a DPP44 power inserter that I picked up from fleabay.