Problem: DLHD - no sat signal and can't enter server info

[jedi]

I'm trying to help a friend with his DreamLink HD receiver with an HD module.

I loaded DL_HDpvr_factory.bin to the receiver and after it installed and rebooted I exited the USB Explorer list and pressed [MENU] button - went to Configuration then to System Recovery - entered 0000 as the PIN and went to "Factory Set" and pressed OK - accepted the warning and reset all data.
I selected the Menu Language "English"
Pressed the [MENU] button went to Utilities - selected Data Transfer - and installed the DL-HDpvr_121.bin file.
After it loaded and rebooted - again went to the Configuration - then to System Recovery - entered PIN 0000 and did the Factory Set.

When I go to Configuration - Network Settings - I can't enter any server info - it won't take the Password.
I used 0000 and also tried 0227

Also when I go to the Installation - Dish Settings - I don't get any signal on an sats. I've tried different dishes and LNBs - but the signal always stays red.

Any ideas?

[whoknows]

You didn't say which factory bin you installed so try this one>>http://www.satfix.net/attachment.php?attachmentid=17307&d=1357768192

This DLHD is one of the older boxes?

[jedi]

You didn't say which factory bin you installed so try this one>>http://www.satfix.net/attachment.php?attachmentid=17307&d=1357768192

This DLHD is one of the older boxes?
Sorry - it was the DL_HDpvr_factory_106.bin file that I installed.

It just has dREAMLINK on the front panel and doesn't have any T4 or T5 markings anywhere. The motherboard says Dream Link Rev 1.3 It has a red module inside that says DM Ver0.5 and has rubber heat sink on it. It is a BROADCOM BCM4500KQMG chip.

In another thread here dishUser identified it as a DreamLink HD with an HD module.

[holly2012]

Menu Dish settings scroll to PID click it then scroll to transmission and make sure its set to DVBS QSPK if it isn't set it to that

[jedi]

Menu Dish settings scroll to PID click it then scroll to transmission and make sure its set to DVBS QSPK if it isn't set it to that

Yes it is set to DVBS QSPK

[torpainter]

you might have to load factory file again to get server password reset If loading by usb does not work load factory file with loader program
as far as signal post your hardware set-up and your settings