PDA

View Full Version : Nfusion HD question ?


Stu Gots
04-01-2014, 06:01 PM
I am attempting to use x-x client with my Nfusion HD. I run x-x client and the screen tells me I am connected, login successful, but hangs at "waiting for requests ". Any ideas on what I may have overlooked ?
Any help would be greatly appreciated

Regards

Stu :thumbsup:
62bug
04-01-2014, 09:14 PM
sounds like the nfusion is not sending requests to the server
Stu Gots
04-01-2014, 10:42 PM
What should I be checking ?
ivanme
04-04-2014, 01:20 AM
What should I be checking ?


Have you checked out the Goo 3 common discussion threads
Mavrick
04-04-2014, 02:35 PM
[QUOTE=Stu Gots;1060177]I am attempting to use x-x client with my Nfusion HD. I run x-x client and the screen tells me I am connected, login successful, but hangs at "waiting for requests ". Any ideas on what I may have overlooked ?
Any help would be greatly appreciated

Regards

[QUOTE] sounds like the nfusion is not sending requests to the server[QUOTE]

The Nfusion does not send request to the server, it sends requests to the xx-client which then forwards it to the server. The "waiting for requests " means the client is waiting for the request from the Nfusion which is done via network-cable.
When you select Nfusion in the xx-client ini it shuts off the serial port and then uses the network port, you also have to enter the Nfusion's IP in the xx-client ini so it knows which devise on your network to listen too.
Newfygarge
04-04-2014, 07:49 PM
sounds like you've got some wrong info on your NFHD.
jets
04-08-2014, 02:47 AM
You need to go into the NFHD network connection setting and set the gateway to the IP of the PC or router running xx-client. So you will have to set the NFHD to static and then assign the gateway.
Stu Gots
04-09-2014, 08:50 PM
To be clear then, you are saying that there is no need to use the serial cable at all? I have set the gateway in the receiver network settings to that of the pc running x-x client. STB ip has been set to static. The receiver still will not communicate with the computer running x-x client.
Any ideas and thank you for the reply

Regards

Stu
jets
04-10-2014, 01:04 AM
No you do not need serial cable the CW are sent over the LAN.
Stu Gots
04-10-2014, 07:26 AM
It turns out that if I "hard wire" connect the Nfusion HD stb all woks fine. My problem stems from my attempts to use a shared wired connection on my laptop which is running the x-x client. Any suggestions on what the problem might be? If I connect my Nano to the same shared wireless connection, it works fine.

Regards

Stu :thumbsup: