Nano lite has lots of channels...it thinks.

[Steve44]

I have a strange problem. The channel list showed 2 and 3 of the same channel, lets say ch105, but shows it as on 119, and on 110, and on 118. I Did a default, then re-scanned 110/118/119. I get the channels I'm supposed to but in the guide and the channel list, I see duplicates after scanning. I scanned each satellite separately, and when I was done, it still looks like I have 2, and sometimes 3 of the same channel, of course only 1 of them works. Any idea how to solve this?

Thanks in advance.

[torpainter]

I have a strange problem. The channel list showed 2 and 3 of the same channel, lets say ch105, but shows it as on 119, and on 110, and on 118. I Did a default, then re-scanned 110/118/119. I get the channels I'm supposed to but in the guide and the channel list, I see duplicates after scanning. I scanned each satellite separately, and when I was done, it still looks like I have 2, and sometimes 3 of the same channel, of course only 1 of them works. Any idea how to solve this?

Thanks in advance.
Does the correct sat appear in settings before you scan?

[Condor]

...Or you scanned it multiple times without first deleting channels or doing factory reset.........

[Steve44]

Does the correct sat appear in settings before you scan?

Yes it does. I always make sure of a lock with the proper name(otherwise there's no point in scanning)

[Steve44]

...Or you scanned it multiple times without first deleting channels or doing factory reset.........

Read my post again. When I say a default, I mean that I did a factory reset, a fresh start if you will. Like I made very clear in my post, I scanned each satellite separately, but only once each.

Thanks for your help so far.

[torpainter]

reload software file and factory default then try again Do a regular scan

[Glatt]

Same channel name but on a different Satellite will come up every time!

[JCO]

Sounds like a switch going fubar.

[Steve44]

Sounds like a switch going fubar.

Changed the switch to an sw-21 on Saturday, DiSEqC was shot.

Looks like I'm going to have to manually delete the non-working ones, or just put up with it.
Again, thanks for offering your advice guys!

[JCO]

If you delete all channels and do a fresh scan you should not have duplicates..

[Jionni_dream]

Im having the same problem. When I scan both sats 110 119. Even after doing a factory reset and deleting all channels, I still get doubles. Everytime I rescan and it produces channels for both sats.. for ex. 121 for 110 and 121 119.. I cant figure it out. I did also notice that the channels are sticking. for ex. when i put it on channel 830 ill have to go up or down a channel and then back down to 830? Any suggestions would be great.. Im not sure if these problems are related.. Thanks

[hutch]

did you change out the switch so you can rescan without dupes?