Channel list

[roper7]

oading instructions:
1) Make sure "Short Channel Name" is selected in the Installation->Options menu
2) put CHLIST-C.LDB on FAT32 formatted usb flash stick and plug usb to receiver
3) a USB Explorer windows will appear allowing you load the file. Select and Press OK to load the file.
4) when file is loaded, do a soft reboot (turn off and on with your remote)
5) set up the switch settings and private server infos

Where it says set up the switch settings, what does that mean.

When installing do you put in before the dish settings or after?

[whoknows]

A channel list is a list that someone else has scanned the satellites with their receiver>>and their settings..If you want to use their list then install and then go in and change or at least check your antenna settings as the chance that their antenna settings is the same as your is slim. capeesh

PS: there is nothing better than scanning your own channels as you are on a different part of the dirt than someone else. I would never use a channel list from another person. jmo

[roper7]

A channel list is a list that someone else has scanned the satellites with their receiver>>and their settings..If you want to use their list then install and then go in and change or at least check your antenna settings as the chance that their antenna settings is the same as your is slim. capeesh

PS: there is nothing better than scanning your own channels as you are on a different part of the dirt than someone else. I would never use a channel list from another person. jmo

I am missing channels 138 and 239 how do get those channels back

[dishuser]

just scan the tp

[whoknows]

138 is on tp 12326 and 239 is on 12472

[roper7]

138 is on tp 12326 and 239 is on 12472

How do I put those TP's in.I have never done this before

[dishuser]

How do I put those TP's in.I have never done this before
go to manual scan and scroll thru the frequency's

[roper7]

I found the frequency whats the next step

[dishuser]

I found the frequency whats the next step
press the red button and scan

[roper7]

press the red button and scan

I did as you asked but not holding the channel I scaned but still no channel.