gwrowe
05-15-2014, 11:24 PM
Here is what you need to do, to get your Ultra lite HD going:
Go to files section and download recent firmware file 1.11
Uzip file to usb stick!
put usb stick into side or rear usb port in receiver
Make sure you have installed the JB 200 tuner, connect all cables, RG6, HDMI, etc.
Turn on receiver and wait for it to boot!
Once it has booted go into the menu to Tools and do factory Default!
After fac. default receiver will reboot itself, once it is done go back to tools and go to load by usb, follow instructions
Once the firmware is installed do another fac default, then do a remove usb safely.
go to installations and setup- sat's.
There is no need for loaders or fac files, and if anyone tells you different they are full of bunk!
Go to files section and download recent firmware file 1.11
Uzip file to usb stick!
put usb stick into side or rear usb port in receiver
Make sure you have installed the JB 200 tuner, connect all cables, RG6, HDMI, etc.
Turn on receiver and wait for it to boot!
Once it has booted go into the menu to Tools and do factory Default!
After fac. default receiver will reboot itself, once it is done go back to tools and go to load by usb, follow instructions
Once the firmware is installed do another fac default, then do a remove usb safely.
go to installations and setup- sat's.
There is no need for loaders or fac files, and if anyone tells you different they are full of bunk!