figure this out !!!

[brodie_stewart]

ok i finally discovered why i haven't been pickin up 82, i now have both 91 and 82 locked in at 100%.

now for scanning purposes i connected 82 sat directly to my nfusion HD receiver. now im in antenna setup and when i select 82 from the list and here my setup.

sat bell 82
lnb 11250
disec is auto
legacy disabled
network search no
search option all
tp list 17 12457 V 21500

now the problem i have been having with this from day one is that it either shows no signal or a signal of 43% no matter what i do. its not the wiring or cables or grounds or anything like that cause i swapped everything out. am i missing somthing or do i have to do a factory reset or what.

[brodie_stewart]

the only transponders that i was able to lock onto is 15 and 16 and only have me 17 channels

[Glatt]

Try SW21 port2 for 82

[airjam]

the only transponders that i was able to lock onto is 15 and 16 and only have me 17 channels

Your 8PSK board is bad or missing.... You will not lock on to any HD transponders without a good 8PSK board.

[riverman]

Your 8PSK board is bad or missing.... You will not lock on to any HD transponders without a good 8PSK board.

could also be missing the jumper or the jumper is connected wrong

[alexandergallant]

If 4x1 switch
82 should be on port 4

[dishuser]

If 4x1 switch
82 should be on port 4
no it shouldn't

[brodie_stewart]

new board is ordered, it seems it will only pick up those 2 transponders due to the fact they are only SD. same as my bell 3100 reciever will only detect those 2 as well. so its my board. Thanks for your help.