PDA

View Full Version : 129 locked but no channels


Grassracr
08-11-2014, 02:01 AM
I get hd channels off sat110 just fine but only find 23 channels on sat129. I seem to have good signal 66 or so on tp 21 but when i do a scan it skips all the tp's when i know there is signal on them. For instance i get signal on tp 42 but finds nothing on manual scan.
Nostradamus
08-11-2014, 02:17 AM
66 is really not an adequate signal, you should be getting at least 80
Grassracr
08-11-2014, 02:37 AM
Im about 66 si and 66 sq. I thought 129 sat was always lower than 119 and 110
lolipop
08-11-2014, 03:31 AM
On jynx 66 is just where a channel comes and goes. Scanning will skip.
iq180
08-11-2014, 12:50 PM
I get hd channels off sat110 just fine but only find 23 channels on sat129. I seem to have good signal 66 or so on tp 21 but when i do a scan it skips all the tp's when i know there is signal on them. For instance i get signal on tp 42 but finds nothing on manual scan.
You have something blocking sat 129.0w like a tree or building or your dish skew is off just a small bit.
kijiji
08-11-2014, 01:19 PM
signal really dose'nt matter its quality you want to look for.
diode
08-11-2014, 04:21 PM
do you have a jb200 tuner or a dvbs2 tuner installed or both? If both make sure 129 is set to the jb200.
Grassracr
08-11-2014, 10:10 PM
Only have jb200. What kind of signal quality is minimum for 129?
iq180
08-11-2014, 10:21 PM
Only have jb200. What kind of signal quality is minimum for 129?
It should be around 80% Q.
Fibroso
08-12-2014, 11:12 AM
What Jynxbox Ultra HD are you talking about? Where are you? What are your settings? Guys, not enough info here for a diagnostic.
Grassracr
08-12-2014, 10:51 PM
In WI and its a v3 clone. 119 port 1 110 port 2 129 port 3 on 1000.2 dish. I factory reset last night and loaded 244 dual did auto scan with network on and found 63 channels on 129.
Terryl
08-12-2014, 11:07 PM
Look at the back of your receiver where the LNB coax connects, what does it say as far as the MAX DC current???
Fibroso
08-13-2014, 02:12 AM
In WI and its a v3 clone. 119 port 1 110 port 2 129 port 3 on 1000.2 dish. I factory reset last night and loaded 244 dual did auto scan with network on and found 63 channels on 129.
Set your lnb as ocs-dp, if you had a v6, you would have been watching tv.