60" vizio will not work with LS HD air

[zephyrus]

Connected new Vizio smart TV to LS. Works great for a few minutes. Then I loose audio and get "Bad or No Signal" displayed. I can't seem to turn the Wi Fi off on the vizio. I am hard wired to my network with LS. Does anyone know what's going on and a solution?

Thanks!

[Nostradamus]

is the bad or no signal message being displayed a receiver error message or one generated by the tv? If it is the TV then you have a bad HDMI cable, if it is being generated by the receiver then the issue lies in your box setup or it has a tuner failuire

[zephyrus]

Yes, limesat keeps dropping signal from 90 to 20. Never did this until I installed new TV. Other receiver (dreamlink) has no issues.
Could it be a heat problem? problem is I only loose audio.

[Nostradamus]

the device displaying video (TV) has no bearing on signal strength. If other receiver is working well I would say it is something wrong with lime

[zephyrus]

Yes I agree with you. can not figure out why signal drops to 20%, I loose audio and still have video. I would think when I loose signal I would loose both.

[Nostradamus]

normally you do so sounds like some type of tuner issue

[zephyrus]

Yeah! That's what I am Thinking. I swapped cables, etc. and still the same. Looks like I need to start testing a new Receiver. I have been looking at ismart m100. Thanks for your support! any suggestions on receivers? T5 or 1smart ?

[jvvh5897]

Might be an issue with the RF noise from TV messing up the satellite box--put a little more distance between them or try a little metal shielding temporarily. Could be some sort of ground loop issue too maybe try running extension cord to box from a few rooms away.